Answer

Mar 20, 2025 - 01:58 AM
To change the drill chuck on the Ronix 2513 Electric xxxx Driver Drill, follow these steps:
1. Before any work on the power tool, set the rotational direction switch to the center position to prevent unintentional actuation of the on/off switch.
2. Completely open the keyless chuck by turning it in a rotation direction until the tool can be inserted.
3. Insert the tool into the chuck.
4. Firmly tighten the collar of the keyless chuck by hand in the rotation direction.
If you need to replace the drill chuck, follow these additional steps:
1. Before any work on the power tool, set the rotational direction switch to the center position to prevent unintentional actuation of the on/off switch.
2. The keyless chuck is secured with a securing xxxx against unintentional loosening from the drill spindle. Completely open the keyless chuck and unscrew the securing xxxx in the rotation direction. Please note that the securing xxxx has a left-hand thread.
3. Clamp the short end of a hex key into the keyless chuck. Place the machine on a stable surface (e.g., a workbench). Hold the machine firmly and loosen the keyless chuck by turning the hex key in the rotation direction.
4. If the keyless chuck is tightly seated, give the long end of the hex key a light blow to loosen it. Remove the hex key from the keyless chuck and completely unscrew the keyless chuck.
5. To mount the new drill chuck, xxxx the securing xxxx in a counter lock-wise direction into the opened keyless chuck with a tightening torque of approximately 4-5Nm. Always use a new securing xxxx , as the threads are covered with a thread-locking compound that loses its effect after multiple uses.
Please refer to the user manual for more detailed instructions and safety precautions.
Source: https://manuals.plus/ronix/2513-elect... xxxx -driver-drill-manual
Add New Comment