User Manual Q&AAnswer
Mar 20, 2025 - 01:35 AM
To install and configure the Schneider Electric A9MEM152 Wireless Communication Energy Sensor, please follow the instructions provided in the manual. Here is a step-by-step guide:
1. Before installation, ensure that the PowerTap device is only installed and maintained by qualified professionals. Do not install the device if any damage is observed during unpacking.
2. The PowerTap device should be installed inside electrical panels or switchboards, behind a door or plate, to make it inaccessible to unauthorized persons. The electrical panels must meet the requirements of applicable standards (IEC 61439-1) and be installed in compliance with current installation and safety rules (IEC 61140).
3. It is important to respect all relevant local, regional, and national regulations while installing and using the PowerTap device.
4. Make sure to download the technical documents for Acti9 products from the Schneider Electric website (www.schneider-electric.com) for additional information.
5. Turn off all power supply sources before installing and during maintenance of the equipment to avoid the risk of electric shock, explosion, or arc flash.
6. Do not use the PowerTag product for voltage testing purposes. Use a Voltage Tester instead.
7. The PowerTap device has power-supply and voltage measurement connections. Connect the neutral wire of the A9MEM1520 using an 18 mm cable end or strip over 18 mm to avoid tightening against the insulating material.
8. The PowerTap device must be associated with an easily accessible upstream protection and circuit-breaker system, marked with callout A in the schematic provided in the manual. Ensure that the upstream protection and disconnection devices are clearly identified and labeled.
9. Follow the provided electrical diagram for proper installation and connection.
10. Take note of the technical data for the PowerTap device, including nominal voltage, operating range, frequency, maximum power consumption, maximum current, operating temperature, overvoltage and measurement category, pollution degree, altitude, relative humidity, impact resistance index, radio communication details, and accuracy.
11. If you have any further questions or need assistance, refer to the user manual of the concerned concentrator or contact Schneider Electric for support.
Please note that this answer provides a general overview of the installation and configuration process. For detailed instructions and specific information, it is recommended to refer to the Schneider Electric A9MEM152 Wireless Communication Energy Sensor manual.
Add New Comment