User Manual Q&AAnswer
Mar 20, 2025 - 01:20 AM
To install the Commercial Electric PKL004IS3-UL 3-Light LED Puck Light Kit, follow these steps:
1. Before installation, ensure that the surface where you want to mount the lights is clean and free of moisture, oil, grease, dust, and dirt.
2. If using the double-sided tape provided, mark the desired area for installation and remove one side of the tape. Secure the tape to the LED puck light. Then, remove the other side of the tape and secure the light to the desired location.
3. Affix the self-adhesive wire guides to guide and secure the linking cord and AC/DC plug-in adapter cord as needed.
4. If your light has a movement sensor, wave your hand once below the sensor to turn on the light and wave again to turn it off. To activate the dimming function, hold your hand under the sensor for a few seconds after the light is turned on. The brightness will cycle from highest to lowest and then from lowest to highest. Move your hand away from the sensor range at your desired brightness, which will be memorized by the light even after the power is cut off.
5. If you want to link more lights, make sure they are from the same series (PKLDD4IS3-UL). Only connect lights of the same series and ensure that only one light receives the main power input from the supply circuit to avoid damage or fire.
6. If you need to link lights together, use the provided 17-inch cord (D) or 40-inch cord (E) to connect them.
If you have any further questions or encounter any problems during installation, you can contact Commercial Electric Customer Service at 1-877-527-0313 or visit www.HomeDepot.com.
Add New Comment