Answer

Mar 20, 2025 - 01:01 AM
To install the 10L0L B07PLBD17J Club Car DS Heavy Duty Leaf Spring U Bolt Plus Nuts, please follow the steps provided in the instruction manual:
1. Park the vehicle on level ground.
2. Turn the key to the "OFF" position and remove it from the switch.
3. Make sure the parking brake is set.
4. Loosen the screws of the rear tire with a 3/4-inch (19mm) socket.
5. Raise the frame of the rear suspension with a jack to hang the rear tire in the air.
6. Remove the screws of the rear tire with a 3/4-inch (19mm) socket and remove the rear tire. Place the tire under the chassis for safety.
7. Remove the xxxx of the shock absorber lower terminal with a 9/16-inch (14mm) spanner.
8. Remove the shock absorber lower terminal cushions.
9. Loosen the U bolt nuts with a 9/16-inch (14mm) spanner, then remove the U bolt.
10. Install a new U bolt.
11. Install the spring pad.
12. Install the screws on the lower terminal of the rear shock absorber with a 9/16-inch (14mm) spanner.
13. Install the rear wheel.
Following these steps will complete the installation of the 10L0L B07PLBD17J Club Car DS Heavy Duty Leaf Spring U Bolt Plus Nuts.
If you require further technical support or have any additional questions, you can reach out to 10L0L through their website (www.10l0l.com), email (sale_service@10l0l.com), Facebook (zhong zaiyang), or YouTube (10L0L).
Add New Comment