User Manual Q&AAnswer
Mar 20, 2025 - 12:26 AM
To mount the Vision.Net RS232 and USB Module on a compatible TS35/7.5 DIN rail, follow these steps:
1. Tilt the module backwards slightly.
2. Fit the module over the top hat of the DIN rail.
3. Slide the module down until it is fully engaged with the top hat.
4. Push the module forward to fully engage it with the DIN rail.
5. Gently rock the module back and forth to ensure it is locked in place.
To remove the module from the DIN rail, follow these steps:
1. Turn off and disconnect the wiring.
2. Gently pry the module from the bottom using a slotted screwdriver if necessary.
Please refer to the installation and operation instructions in the user guide for more detailed information and illustrations.
Add New Comment