Answer

Mar 20, 2025 - 12:16 AM
To install the relaxn 530694 Mako Series Carbon Fibre Push Button Switch Panel, follow these steps:
1. Disconnect all power (DC) before starting the installation process.
2. Cut an opening for the mounting location using the template provided with the switch panel.
3. Connect the positive wire (red) to the DC power source (such as the batteries) and the LED negative feed wire (yellow) to a DC negative bus bar.
4. Connect the positive wires of your devices to the load terminals of the switches. Connect the negative wires of the devices to a negative bus bar. Apply the desired labels to the recessed area at the corresponding branches.
5. Mount the switch panel using the included self-tapping screws.
6. Reconnect the DC power and turn on and off all branch circuits to check if the panel works normally.
Note: It is important to connect the switch panel to a fuse board using suitable fuses for your specific application.
For more detailed information and visual references, please refer to the relaxn 530694 Mako Series Carbon Fibre Push Button Switch Panel User Manual.
Add New Comment