How do I install the GE APPLIANCES Smart Designer Custom Insert with Dimmable LED Lighting? (GE Appliances Smart Designer Custom Insert Dimmable LED Lighting Owner's Manual)

Answer

manuals.plus

Mar 19, 2025 - 12:12 PM

Sure! Here are the step-by-step instructions for installing the GE APPLIANCES UVC9300SLSS 30 Inches Smart Designer Custom Insert with Dimmable LED Lighting:

1. Prepare the cabinet: Make sure the custom cabinet has a rectangular hole to accommodate the custom hood insert. The hole should be the same size for both wall and island installations. Ensure that the cabinet is level and parallel to the hood.

2. Remove the packaging: Remove all packaging materials from the hood, including the protective plastic wrapping.

3. Install the hood: Insert the hood into the cabinet opening. Fasten it with screws, starting with one corner and then diagonally fastening the remaining screws. Make sure the back surface of the hood is at least 1 inch away from the back wall and the front surface is at least 3 inches away from the front cabinet panel.

4. Electrical connection: Remove the electrical junction box cover and knockout. Feed the power supply cable through the hole and secure it with a strain relief. Connect the white lead of the power supply to the white lead of the range hood using a wire nut. Connect the black lead of the power supply to the black lead of the range hood using a wire nut. Connect the house ground wire under the green grounding xxxx .

5. Recirculation option (if used): If you are installing the hood for recirculation, cut a hole in the soffit for the exhaust duct and install the vent grill over it. Seal the duct joints with duct tape.

6. Finalize installation: Insert the filters into the hood. Check the operation of the lights and blower. Finish the custom cabinetry.

Please note that these are general instructions, and it's always best to refer to the specific installation instructions provided in the owner's manual for your model.