How do I install the MAPEI Non-Programmable Floor-Heating Thermostat? (MAPEI Non-Programmable Floor-Heating thermostat Instruction Manual)

Answer

manuals.plus

Mar 19, 2025 - 07:58 AM

To install the MAPEI 2855401 Non-Programmable Floor-Heating Thermostat, please follow the instructions provided in the instruction manual. Here is a step-by-step guide:

1. Ensure that the power to the heating system is turned off before starting the installation process.

2. Determine the location for the thermostat. It should be installed on an interior wall, away from direct sunlight, drafts, and other heat sources.

3. Connect the thermostat to the electrical supply. The thermostat is compatible with both 120 V and 240 V systems. Make sure to follow the wiring diagram provided in the Mapeheat Wiring Diagrams Guide to connect the thermostat correctly.

4. Mount the thermostat on the wall using the provided mounting plate and screws. Ensure that the mounting plate is securely attached.

5. Connect the floor sensor to the thermostat. The floor sensor should be placed in the floor heating system's conduit or attached to the floor using adhesive or clips. Follow the instructions in the quick start guide for proper sensor placement.

6. Connect the heating system to the thermostat. The thermostat has terminals labeled "L" and "N" for the line and neutral connections. Follow the wiring diagram to make the appropriate connections.

7. Once all the connections are made, turn on the power to the heating system.

8. Set the desired temperature on the thermostat using the up and down buttons. The thermostat will maintain the set temperature by turning the heating system on and off as needed.

Please note that these instructions are a general guide, and it is essential to refer to the specific instructions provided in the MAPEI 2855401 Non-Programmable Floor-Heating Thermostat Instruction Manual for accurate installation guidance.