User Manual Q&AAnswer
Mar 19, 2025 - 03:08 AM
To connect your effect pedals to the Harley Benton 520943 50M Spaceship Power, follow these steps:
1. Connect the device to the mains using the supplied power cord to put the device into operation.
2. Use a suitable voltage supply cable to connect effect pedals or similar devices that require 24 V supply voltage at a maximum of 2000 mA to the output 1.
3. Use a suitable voltage supply cable to connect devices with high power consumption (i.e., multi-effect devices) that require 9 V supply voltage at a maximum of 3000 mA to the output 2.
4. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V supply voltage at a maximum of 250 mA to the outputs 3 - 4.
5. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V supply voltage at a maximum of 500 mA to the outputs 5 - 7.
6. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V, 12 V, or 18 V supply voltage at a maximum of 500 mA, 375 mA, or 250 mA to the outputs 8 - 9. Set the associated switch above the output to the position of the required voltage. Ensure that the maximum output power of 31.5 W is not exceeded.
7. Use suitable voltage supply cables to connect devices such as smartphones or tablets to the USB outputs.
8. Each operational output 1 - 9 is indicated by a green LED. If an output is switched off due to overload, the LED turns off. In this case, disconnect the pedal causing the overload from the device. After approximately 2 seconds, the normal voltage supply will be restored to that output.
9. To switch off the device, disconnect the power cord from the mains.
Please refer to the Harley Benton 520943 50M Spaceship Power User Guide for more detailed instructions and safety information.
Add New Comment