User Manual Q&AAnswer
Mar 18, 2025 - 10:02 PM
To install the VENETA 65101-40160-D Roller Blinds with Raceway inside the window frame, follow these steps:
1. Attach the blind brackets and extensions to the two ends of the raceway. Determine whether the tension dial will be on the left or right side of the blind. The side with the tension dial should use the tension dial end bracket.
2. Ensure that the extension bolt locks into the raceway's dedicated hole.
3. Fit the blind bracket cover over the blind bracket. Install the raceway into the window opening. It is recommended to secure the screws into the middle holes of the raceway first. This allows for adjustment of the raceway left or right if needed. Once the correct position is determined, secure the screws for all the holes.
4. Make sure the distance between the first xxxx and the window edge is at least 19mm.
To install the blind into the blind brackets:
1. Insert the tension dial into the tongue of the tension dial bracket.
2. Press the end plug and insert the end plug end into the hole of the bracket on the other side.
3. Slide the lock pin in the blind bracket downward into the end plug to prevent the blind from falling. The gap on the end plug end should be about 4.5mm.
After the blind is installed, use a level to check if the fabric's roll is horizontal. If it is not level, adjust the position of the blind brackets to keep the fabric's roll level.
To remove the blind:
1. Use a tool to push the lock pin on the end plug bracket upward.
2. Use a tool to draw back the end plug from the bracket.
3. Finally, remove the blind from the mounting bracket.
For further assistance or questions, you can contact the VENETA customer service team at 1300 836 382.
Add New Comment