User Manual Q&AAnswer
Mar 18, 2025 - 10:01 PM
To hang the George P5421 Kovacs Three Light Pendant, follow these steps:
1. Carefully remove the fixture from the carton and ensure that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove the old fixture, including the mounting hardware.
3. Determine the desired hanging height and thread the rods (G1, G2) to the all thread on the fixture body (H). Pass the wires carefully through each rod as you assemble. Secure the swivel (F) on the canopy (D) onto rod (G1). Feed the wire through the swivel (F).
4. Thread screws (A) into the pre-drilled holes in the crossbar (B), spaced the same distance apart as the holes in the canopy (D). Adjust the length of screws (A) if necessary.
5. Attach the crossbar (B) to the junction box (not included) using the mounting screws (C) (Size: #8-32N*L25mm). Ensure that the side of the crossbar (B) marked "GND" faces out.
Complete Answer: The most common question a user might have regarding the George P5421 Kovacs Three Light Pendant in Coal With Polished is how to hang the fixture. To hang the pendant, you need to follow the instructions provided in the installation manual.
First, carefully remove the fixture from the packaging and ensure that all parts are included. Then, shut off the power at the circuit breaker and remove the old fixture, including the mounting hardware.
Next, determine the desired hanging height and thread the rods (G1, G2) to the all thread on the fixture body (H). Pass the wires through each rod as you assemble. Secure the swivel (F) on the canopy (D) onto rod (G1) and feed the wire through the swivel (F).
Thread screws (A) into the pre-drilled holes in the crossbar (B), spacing them the same distance apart as the holes in the canopy (D). Adjust the length of the screws (A) if necessary.
Attach the crossbar (B) to the junction box (not included) using the provided mounting screws (C). Make sure that the side of the crossbar (B) marked "GND" faces out.
Once the fixture is securely hung, you can proceed with connecting the wires according to the instructions in Figure 2 of the manual. Make sure all wire connectors are secured and, if your junction box has a ground wire, connect the fixture's ground wire to it. Otherwise, connect the fixture's ground wire directly to the crossbar (B) using the green xxxx provided.
After connecting the wires, tuck the wire connectors neatly into the ceiling junction box.
To finish the installation, slide the canopy (D) over the screws (A) and secure it with the finials (E). Install three candelabra base bulbs (M) up to 60 watts each or CFL/LED equivalents (not included) according to the fixture specifications. Do not exceed the maximum wattage rating.
Loosen the finial (I) and socket cup (K), slide the glass shade (N) over the bulb (M), and hang the glass shade (N) on the holder (L). Slide the socket cup (K) over the all thread (J) and secure the glass shade (N) with the finial (I).
Please note that the illustration in Figure 1 of the manual is for installation purposes only and may not be identical to the fixture you purchased.
It is important to have the fixture installed by a qualified electrician to ensure proper wiring and installation. Once the installation is complete, you can restore power to the junction box and test the fixture.
Add New Comment