How do I install the STANLEY Hammer Drill? (Stanley Hammer Drill Installation Guide)

Answer

manuals.plus

Mar 18, 2025 - 09:55 PM


To install the STANLEY HD01 Hammer Drill, follow these steps:

1. Start by gathering all the necessary parts and tools mentioned in the parts list.

2. Begin by attaching the motor cap assembly (item 51A) to the main housing assembly (item 57) using the screws provided.

3. Install the O-rings, quad ring, motor seal washer, dowel pins, and backup rings as indicated in the parts list. Make sure to lubricate the O-rings with a compatible lubricant before installation.

4. Attach the couplers (items 12 and 13) to the appropriate ports on the main housing assembly.

5. Install the lever (item 15) onto the main housing assembly.

6. Attach the idler shaft (item 23), idler gear (item 24), drive gear (item 25), key (item 26), and reversing spool (item 27) according to the instructions provided in the manual.

7. Install the remaining components, such as the trigger (item 33), compression coil spring (item 34), roll pin (item 35), and check plug (item 29), following the manual's instructions.

8. Apply the appropriate stickers and decals (items 20, 21, 22, 36, 37, 38, 39, 41, 43, 45, 56, 58, 67) to the hammer drill as indicated.

9. Finally, refer to the manual for any additional instructions or safety precautions.

Please note that this answer is a general overview of the installation process. For more detailed instructions and illustrations, it is recommended to refer to the official STANLEY HD01 Hammer Drill Installation Guide.