User Manual Q&AAnswer
Mar 18, 2025 - 09:52 PM
To install the STANLEY CT15 Crimping Tool, follow these steps:
1. Start by gathering all the parts listed in the part list provided in the manual.
2. Begin the installation by attaching the retaining ring (part no. 118) to secure the components.
3. Install the HSHCS screws (part no. 144) using the specified size and length (5/16-18 x 1-1/4) to assemble the tool.
4. Place the O-rings (part nos. 7626, 9330, 294, 360, 1259) in their designated locations as indicated in the part illustration.
5. Attach the adapters (part no. 936) to the appropriate positions.
6. Install the HSHCS screws (part no. 1521) using the specified size and length (1/4-20 x 1) to secure the components.
7. Insert the roll pin (part no. 1534) into its designated slot.
8. Install the setscrews (part no. 7736) to ensure proper alignment and stability.
9. Place the steel balls (part no. 1608) in their designated positions.
10. Install the valve spool (part no. 1809) and secure it with the valve spool xxxx (part no. 1812).
11. Attach the spring (part no. 16556) to provide tension and support.
12. Install the back-up ring (part no. 18050) and the relief valve (part no. 21424) in their designated locations.
13. Place the T-seal (part no. 21847) and the O-ring (part no. 21848) in their respective positions.
14. Attach the capscrews (part no. 22147) to secure the components.
15. Install the push rod (part no. 65726) and the O-ring (part no. 1259) in their designated locations.
16. Attach the die yoke (part no. 28294) to the tool.
17. Install the valve sleeve (part no. 38622) and the compression spring (part no. 39925).
18. Attach the valve handle (part no. 39939) and the trigger guard (part no. 51182).
19. Install the trigger (part no. 51183) and secure it with the setscrews (part no. 52534).
20. Attach the adapter (part no. 58439) and secure it with the retaining ring (part no. 58440).
21. Install the sleeve (part no. 58441) and the oil tube (part no. 58442).
22. Place the piston (part no. 58443) and the cylinder (part no. 58444) in their designated positions.
23. Attach the cylinder head (part no. 62286) to complete the assembly.
24. Finally, affix the CT15 sticker (part no. 76653) and the warning sticker (part no. 7961) for identification and safety purposes.
Please note that this is a general installation guide based on the provided information. For more detailed instructions and diagrams, refer to the official STANLEY CT15 Crimping Tool Installation Guide or consult a professional if needed.
Add New Comment