Answer

Mar 18, 2025 - 09:42 PM
To install the Glacier Bay 20203-9010H 3-Piece Bath Hardware Set with Towel Bar, follow these steps:
1. Before beginning installation, ensure all parts are present and compare them with the Package Contents and Hardware Included list. If any part is missing or damaged, do not attempt to install the product.
2. Mark the mounting location by removing the set xxxx from the base of the product posts. Place the product in the desired mounting location, use a level to position it accordingly, and lightly mark the outline of the post(s) with a pencil.
3. Center the mounting bracket within the marked post location(s) and mark where the xxxx holes will be drilled. Repeat this step for each bath accessory. The included template may be used to mark the mounting locations for the towel bars.
4. Drill 1/4 inch holes in the previously marked locations. Push the plastic anchors flush into the drywall. Fasten the mounting bracket to the wall with the wood screws. Repeat this step for each bath accessory. Note: When mounting the products to a wood wall, fasten the mounting brackets to the wall using the wood screws. There will be no need for drilling or plastic anchors.
5. Place the post over the mounting bracket and secure it with the set xxxx . Repeat this step for the remaining post. Note: Ensure the towel bar is inserted prior to securing the second post to the mounting bracket.
For further assistance or if you have any questions, problems, or missing parts, you can contact Glacier Bay Customer Service at 1-855-HD-GLACIER (1-855-434-5224) from 8 a.m. to 7 p.m. EST, Monday to Friday, and 9 a.m. to 6 p.m. EST on Saturdays.
Add New Comment