User Manual Q&AAnswer
Mar 18, 2025 - 09:34 PM
To install the integrated panel on the U-LINE UHRE515IG01A 15 Inch Integrated Frame Refrigerator, follow these steps:
1. Cut the panel to the dimensions specified in the manual.
2. Optional: Stain or finish the panel to your desired color.
3. Optional: Install handles and hardware on the panel.
4. Fully open the refrigerator door.
5. Starting at the corner, pull the gasket away from the door and continue to remove it from the gasket channel.
6. Lay the gasket down on a flat surface.
7. Align the top of the panel with the top edge of the door and center it on the door.
8. Secure the integrated panel to the door using clamps or a robust tape. U-Line recommends using bar clamps for better security.
9. Using a 7/64" (3 mm) drill bit, drill 6 pilot holes into the wood panel, 1/2" (12 mm) deep, using the holes in the door frame as a guide.
10. Locate 6 of the #6x 1-1/2" (38 mm) screws provided with your unit.
11. Using a Phillips screwdriver, place one xxxx into each of the 6 pilot holes and xxxx them down. Do not overtighten the screws.
12. Ensure the screws sit flush against the bottom of the channel.
13. Remove the clamps from the door.
14. Starting at the corners, re-install the gasket into the gasket channel in the frame. Make sure the gasket is fully seated.
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment