User Manual Q&AAnswer
Mar 18, 2025 - 04:03 AM
To assemble the Eleglide T1 Electric Bike, please follow the steps outlined in the user manual:
Step 1: Install the Handlebar
- Take out the bike and make it stand up.
- Open the clip by loosening the screws on it.
- Place the handlebar in the right position and make sure the clip is in the middle of the bar.
- Lock the clip by tightening the screws.
Step 2: Install the Front Wheel
- Put the bike upside down and remove the temporary protected bar by loosening the nut.
- Insert the front wheel into the fork dropouts and make sure the wheel is fully inserted.
- Remove the nut and one spring on the quick release.
- Slide the quick release through the hub from the opposite side of the brake.
- Slide the spring into the hub and tighten the nut to fix the quick release.
Step 3: Fix the Headset
- Adjust the headset of the bike to the right position.
- Tighten the headset with the M4/M5 socket head wrench.
Step 4: Adjust the Stem Angle (Only for T1 Step-Thru)
- Loosen the stem with the M6 socket head wrench.
- Adjust the stem to the angle you want and fix it by tightening the screws.
Step 5: Install the Headlight
- Place the headlight in the right position.
- Fix the light by tightening the xxxx with the M4 socket head wrench.
Step 6: Install the Taillight
- Connect the wire to the taillight.
- Place the taillight in the right position and tighten the screws to fix it.
Step 7: Fix the Mudguard
- Fix the support of the mudguard by tightening the screws with the M5 socket head wrench.
Step 8: Install the Pedals
Step 9: Install the LCD Display
- Disassemble one of the supports of the display first with the M3 socket head wrench.
- Slightly open another support to get the display stuck on the handlebar.
- Slightly open the disassembled support and buckle it on the handlebar. Fix it with the M3 socket head wrench.
- Fix the display in the middle of the handlebar with the M3 socket head wrench.
- Open the clip of the display button and buckle it on the handlebar. Use the M2.5 hex wrench to tighten the clip and fix the button.
- Connect the display cable with the power cord.
Step 10: Install Spoke Reflectors
Step 11: Install the Seat
- Slide the seat post into the support frame.
- Adjust the seat to a suitable height and fix it by tightening and locking the quick-release clip.
Step 12: Turn the Power on
- Lock the battery and turn the display on. Then it's ready to go!
Please refer to the user manual for detailed diagrams and instructions for each step.
Add New Comment