Answer

Mar 18, 2025 - 03:15 AM
To install the battery in the TESLA TSL-SEN-TAH Smart Sensor Temperature and Humidity, follow these steps:
1. Open and close the bottom cover of the sensor by turning it counterclockwise to open and clockwise to close.
2. Install the CR2032 battery in the correct direction, as shown in the figure in the manual.
3. Make sure the battery is securely placed in the sensor.
4. Close the bottom cover by turning it clockwise until it is tightly closed.
Please refer to the manual for visual instructions and additional information on battery installation.
Add New Comment