User Manual Q&AAnswer
Mar 18, 2025 - 02:48 AM
To install the NEXXT SOLUTIONS NHE-R100 Smart WiFi Relay Switch, please follow the steps below:
1. Cut the fixture or device cable that you want to connect to the relay switch and strip the cable's jacket to expose the bare wires.
2. Remove the terminal xxxx covers on the relay switch. On the output side, attach the wires from the fixture or device to the L (Live) and N (Neutral) terminals on the relay switch. Tighten the terminal screws to ensure a secure connection.
3. Repeat the same procedure on the input side of the relay switch, connecting the two electric wires from the grid. Match the N (Neutral) wire with the Neutral terminal and the L (Live) wire with the Live terminal. Avoid reversing the wires to prevent malfunction or damage.
For more detailed instructions and illustrations, please refer to the "Hardware installation" section in the user guide provided with the product.
Note: It is important to turn off the power at the circuit breaker or fuse before starting the installation process. If you are not familiar with hardwired electrical connections, it is recommended to have a qualified electrician or certified electrical technician perform the installation to ensure safety and avoid voiding the warranty.
Please refer to the user guide for additional information and safety precautions.
Add New Comment