User Manual Q&AAnswer
Mar 18, 2025 - 02:23 AM
To install the SCANSTRUT SC-CW-11F Rokk Wireless Active Charging Cradle, please follow these steps:
1. Unbox the product and insert the installation jig.
2. Ensure that there is enough clearance to open the jaws in the chosen installation area.
3. Make sure that the Nano (device) is horizontal and that the installation area is flat.
4. Use a drilling template to drill four pilot holes (refer to the tools required table in the manual).
5. Feed the cable through the hole.
6. Apply sealant to the four screws.
7. xxxx the product in place.
8. Remove the installation jig.
9. Connect wires or connectors to a 12/24V supply, ensuring a waterproof connection. Fuse according to the input voltage and current.
Please note that Scanstrut recommends installation to be carried out by a qualified electrician. It is important to ensure the correct polarity of all wiring before switching the power on. Additionally, make sure to avoid installing the product in hazardous/flammable atmospheres, such as the engine room.
For further details and safety precautions, please refer to the complete instruction manual provided with the product.
Add New Comment