User Manual Q&AAnswer
Mar 18, 2025 - 01:45 AM
To program your fingerprint on the SPORTS AFIELD SA-HD5-BIO Drop Action Biometric Security Vault, follow these steps:
1. Locate the reset button behind the front panel, inside the right-hand side of the vault.
2. Press the reset button to start the programming process. You will hear one beep and the indicator ring on the front of the door will illuminate.
3. Place and hold the pad of your finger on the scanner until it flashes green and beeps once.
4. Repeat this process at least three more times until you hear two consecutive beeps and see two green flashes.
5. It is important to use the same finger for each recording sequence.
6. Once you have successfully programmed your fingerprint, close and lock the door.
7. To open the vault, place and hold your programmed finger on the scanner. The indicator ring will illuminate green, and the vault will unlock.
Note: If your fingerprint is not accepted, you may see one light flash with one sound. This means the scanner did not read your fingerprint correctly. Try again. If you see five red flashes with five sounds, the scanner read your fingerprint but did not accept it. In this case, you will need to reprogram your fingerprint by following the instructions in section 6 of the manual.
Please refer to the manual for additional troubleshooting tips and information on using the vault safely and effectively.
Add New Comment