User Manual Q&AAnswer
Mar 18, 2025 - 01:41 AM
To connect the Hardrock-500 Amplifier to your transceiver, you will need an AC power cable, a QRP radio, and an antenna. Here are the steps to connect the amplifier:
1. Connect the AC power cable to the AC supply in your area and plug it into the Hardrock-500 Amplifier.
2. Connect your QRP radio to the amplifier using a 50 ohm coax jumper with a PL-259 connector on the amplifier end and the appropriate mating connector on the radio end.
3. Connect your antenna to the amplifier using a PL-259 connector.
4. On the rear panel of the amplifier, you will find RF Input and RF Output connectors. Connect the RF Input to the output of your transceiver and the RF Output to your antenna.
5. If you have an internal automatic antenna tuner (ATU) installed in the amplifier, you can connect it to your antenna using the ATU control on the front panel of the amplifier.
Make sure to follow the specific instructions for your transceiver and antenna to ensure proper connection and operation. For more detailed information, refer to the instruction manual provided with the Hardrock-500 Amplifier.
Add New Comment