How to connect and set DMX start address for lyyt 12-24V RGBW DMX Controller 4x8A? (lyyt RGBW DMX Controller 4x8A User Manual)

Answer

manuals.plus

Mar 17, 2025 - 09:52 AM

To connect and set the DMX start address for the lyyt 12-24V RGBW DMX Controller 4x8A, please follow these steps:

1. Power Connection: Connect the DC power input to the xxxx terminals on the controller. Make sure to use a 12V or 24V power supply within the specified power limits (≤384W/12V or ≤768W/24V).

2. DMX Input Connection: Connect the DMX input to the xxxx terminals on the controller. This is where the DMX signal will be received.

3. DMX Through Connection: If you need to daisy-chain multiple DMX devices, you can use the DMX through connection. Connect the DMX output from the previous device to the xxxx terminals labeled "DMX THRU" on the controller.

4. Setting the DMX Start Address: The start address for the DMX control can be set using the side-mounted DIP switches. Refer to the user manual for the specific DIP switch configuration to set the desired start address. This will determine which DMX channels control the RGBW outputs.

5. Output Connection: Connect the RGBW LED tape to the xxxx terminals labeled "Blue," "Red," "Green," "White," and "V+". Ensure that the positive and negative connections are correctly aligned.

Please refer to the wiring diagram provided in the user manual for a visual representation of the connections.

Note: It is important to follow the electrical and safety guidelines provided in the user manual. If you are unsure or have any specific questions about your installation, it is recommended to consult a qualified electrician or contact the manufacturer for further assistance.