User Manual Q&AAnswer
Mar 17, 2025 - 09:41 AM
To calibrate the Micsig DP750-100 High Voltage Differential Probe, follow these steps:
1. Short-circuit the two input terminals of the probe.
2. Power on the probe.
3. Press and hold the "Zero" button on the probe for 3 seconds.
4. The two indicators on the probe will start flashing simultaneously.
5. After 3 seconds, the zero point calibration is successful.
Please note that this calibration process ensures accurate measurements by setting the reference point for the probe. It is recommended to perform this calibration before starting any measurements.
For more information and detailed instructions, refer to the user manual provided with the Micsig DP750-100 High Voltage Differential Probe.
Add New Comment