User Manual Q&AAnswer
Mar 17, 2025 - 09:06 AM
To install the Hunter 19940 Holly Grove 2 Light Vanity 18 inch, follow these steps:
1. Gather the necessary tools: ladder, screwdriver, pliers, and wire strippers.
2. Before starting the installation, turn off the power by switching off the circuit breakers associated with the wall switch location.
3. Ensure that the lighting fixture is grounded. If the ground wire is not present at the installation site, stop the installation and consult a qualified electrician.
4. All wiring must be done in accordance with national and local electrical codes. If you are unsure or unfamiliar with wiring, consult a qualified electrician.
5. Carefully remove all contents from the packaging.
6. Shut off the power at the circuit breaker and remove the old fixture, including the old mounting bracket.
7. Take out the new mounting bracket assembly from the bag. Remove the cap nuts from the mounting screws.
8. Place the mounting plate over the junction box, ensuring that the mounting screws and nuts extend away from the wall. Adjust the position of the mounting screws if needed to allow the backplate to be flush with the wall.
9. Once the ideal position of the mounting screws has been determined, tighten the nuts on the front of the mounting plate to secure the mounting screws.
10. Pull the house wires through the center of the mounting plate.
11. Secure the mounting plate to the junction box by tightening the screws.
12. Have a helper support the fixture's weight while completing the wiring. Connect the fixture's wires to the power supply wires from the junction box: black to black (live), white to white (neutral), and grounding to grounding (green or copper).
13. Twist the ends of the wire pairs together and secure them with a wire connector.
14. Loop the fixture's ground wire around the grounding xxxx and tighten it. If there is no ground wire from the junction box, contact a qualified electrician.
15. Place the fixture's backplate over the mounting screws so that the threads protrude through the holes on the front of the backplate.
16. xxxx the cap nuts onto the mounting screws until the backplate of the fixture is snugly against the wall.
17. Slide the cover over the threaded post on one end of the fixture and secure it with the finial.
18. Install light bulbs (not included) according to the fixture's specifications, making sure not to exceed the recommended wattage.
19. Place the glass shade over the sockets, sliding one end into the secured cover.
20. Install the remaining cover and secure it with the finial.
21. Turn on the power and test the fixture. Your installation is now complete.
Please refer to the provided owner's manual for any additional information or specific details related to the installation process.
Add New Comment