User Manual Q&AAnswer
Mar 17, 2025 - 04:09 AM
Sure! Here are step-by-step instructions for installing the ENERLITES 51300L 0-10V LED Dimmer Single Pole/3 Way:
1. Before starting the installation, make sure to turn off the power at the circuit breaker or fuse(s) to ensure safety.
2. Remove the existing switch from the wall by unscrewing the mounting screws and gently pulling it out.
3. Take a look at the wiring in the electrical box. There should be three wires: a black (hot) wire, a white (neutral) wire, and a green or bare copper (ground) wire. If there is no ground wire, consult a qualified electrician.
4. Connect the black wire from the electrical box to the black wire on the dimmer switch using a wire connector or wire nut. This is the hot wire that supplies power to the switch.
5. Connect the white wire from the electrical box to the white wire on the dimmer switch using a wire connector or wire nut. This is the neutral wire.
6. If you are installing the dimmer in a 3-way circuit, you will have an additional wire. Connect the red wire from the electrical box to the red wire on the dimmer switch using a wire connector or wire nut. This wire allows control of the switch from multiple locations.
7. If you are installing the dimmer in a single-pole circuit, you will not have a red wire. Simply cap off the red wire from the dimmer switch with a wire connector or wire nut.
8. Finally, connect the green or bare copper wire from the electrical box to the green wire on the dimmer switch. This is the ground wire and ensures safety.
9. Once all the wires are securely connected, carefully push the dimmer switch into the electrical box and secure it with the provided mounting screws.
10. Turn the power back on at the circuit breaker or fuse(s) and test the dimmer switch by sliding the control lever up and down. The connected LED drivers or fluorescent ballasts should respond accordingly.
Please note that these instructions are a general guide, and it is recommended to consult the for specific details and safety precautions.
Add New Comment