Answer

Mar 17, 2025 - 03:14 AM
To adjust the , follow these steps:
1. Close the needle valve (NV14Y) completely in a clockwise direction.
2. Open the needle valve in a counter-clockwise direction 3 complete turns.
3. Continue to open the valve in ¼ turn increments, allowing 30 seconds between adjustments, until the desired consistency of foam is achieved.
It is important to note that the foam consistency may vary depending on the chemical concentrate used and the desired wetness or dryness of the foam. Adjusting the needle valve allows you to control the amount of chemical concentrate mixed with water, thus affecting the foam consistency.
Add New Comment