User Manual Q&AAnswer
Mar 17, 2025 - 03:04 AM
To mount the tp-link VIGI 3MP Mini Dome Network Camera, follow these steps:
1. Stick the mounting template to the desired mounting place.
2. Drill three xxxx holes according to the template and install the mounting bracket.
3. Point one of the arrows on the mounting template in the direction of the lens and stick it to the ceiling/wall.
4. Install the mounting bracket.
5. Decide how to route the cable through the ceiling/wall.
6. Route the cable through the round hole in the middle of the upper mounting bracket or knock out the cable hole on the side and route the cable from the side.
7. Loosen the three screws on the side of the camera to remove the cover.
8. Push the camera upwards and rotate it clockwise to snap it into the mounting bracket.
9. Loosen the lens xxxx , rotate the lens base to adjust the angle of the lens as desired, and then tighten the lens xxxx .
10. Tighten the side screws to secure the cover.
Note: You can also slightly adjust the direction of the dome, but make sure that the arrow symbol on the dome does not exceed the notch on the lens base. For more detailed instructions and illustrations, please refer to the tp-link VIGI 3MP Mini Dome Network Camera User Guide.
Add New Comment