Answer

Mar 14, 2025 - 11:37 PM
To install the battery in the Satel Abax 2 Battery-Powered Device, please follow these steps:
1. Open the device enclosure.
2. Install/connect the battery. Make sure to use the battery recommended by the manufacturer to avoid any risks.
3. If you are installing the AXD-200 detector, after installing the battery, you need to select the type of device as specified in the full manual of the device.
4. For the ASP-200/ASP-201 siren, the battery needs to be properly initiated to obtain the required supply specifications. Refer to the full manual of the siren for instructions on how to do this.
5. Close the device enclosure.
6. Place the device in its intended installation location.
7. Check the signal level received from the device by the ABAX 2/ABAX controller or the INTEGRA 128-WRL control panel. If the signal level is below 40%, consider selecting another installation location. Sometimes, shifting the device a few centimeters can significantly improve signal quality.
8. You can use the ARF-200 tester to check the radio signal strength at the intended installation location without actually placing the device there.
9. For shock detectors or glass break detectors, verify the range of detection in the selected installation location.
10. Open the device enclosure again.
11. If necessary, insert additional cables into the enclosure, such as wired detector cables, probe cables, or extra tamper switch cables.
12. Use wall plugs (anchors) and screws to secure the enclosure base to the mounting surface. Ensure you select the appropriate wall plugs for the type of mounting surface.
13. Close the device enclosure.
14. If the AXD-200 detector is used as a magnetic contact (AMD-200/AMD-201/AMD-202/AVD-200), secure the magnet within the maximum permissible distance to the magnetic sensor.
15. If the AXD-200 detector is used as a flood detector (AFD-200), secure the probe.
16. Configure the device settings as outlined in the manual of ABAX 2/ABAX controller/INTEGRA 128-WRL control panel.
17. Finally, check the device for proper functioning.
Please note that this is a quick installation guide, and for more detailed instructions and information, it is recommended to refer to the full manual of the device available on the Satel website (www.satel.pl).
Add New Comment