Answer

Mar 14, 2025 - 02:55 AM
To assemble the SKIL BW9501-00 Band Saw, please follow the steps below:
1. Start by attaching the motor (part number 24) to the main body of the band saw. Use the provided screws and ensure that the motor is securely fastened.
2. Next, attach the lower door assembly (part number 201) and the upper door assembly (part number 202) to the main body. These doors will provide access to the internal components of the band saw.
3. Install the pulley assembly (part number 203) onto the motor shaft. Make sure it is aligned properly and securely tightened.
4. Attach the upper conductor assembly (part number 204) and the upper support bearing assembly (part number 205) to the upper part of the band saw. These components will help guide the blade during operation.
5. Install the lower conductor assembly (part number 208) and the lower support bearing assembly (part number 209) to the lower part of the band saw. These components will also assist in guiding the blade.
6. Attach the miter gauge assembly (part number 210) to the designated slot on the band saw. This will allow for accurate angled cuts.
7. Finally, connect the power cord (part number 39) to the band saw and plug it into a suitable power outlet.
Please refer to the provided part numbers and descriptions to ensure the correct components are installed in the appropriate locations. For further details and illustrations, please consult the SKIL BW9501-00 Band Saw instruction manual.
Add New Comment