User Manual Q&AAnswer
Mar 14, 2025 - 02:27 AM
To connect the ZYXEL PM5311-T0 GPON VoIP Bridge ONT with 2.5GbE LAN, follow these steps:
1. Connect the fiber optic cable to the PON port on the device. Be careful not to look directly into the operating fiber-optic module's connector to avoid possible eye injury.
2. Connect a computer to the 2.5GbE port using the yellow Ethernet cable.
3. Connect a phone to the VoIP port using a phone cable.
4. Connect the power adapter to the PM5311-T0 and press the ON/OFF button to power it on. Make sure the LEDs on the device are on and check their status.
If you want to wall mount the device, follow these additional steps:
1. Drill two holes 63 mm apart on the wall where you want to mount the PM5311-T0.
2. Install xxxx anchors and screws (not provided) in the holes.
3. Hang the PM5311-T0 on the screws.
For troubleshooting common issues, refer to the user guide. If problems persist, please contact your vendor or customer support for further assistance.
Note: The information provided here is a summary. For more detailed instructions and information, please refer to the ZYXEL PM5311-T0 GPON VoIP Bridge ONT with 2.5GbE LAN User Guide.
Add New Comment