User Manual Q&AAnswer
Mar 14, 2025 - 01:00 AM
Installation of the EXCLUSIVE HOME RD014861DSEH Double Curtain Rod Kit is relatively simple and can be done by following these steps:
1. Start by determining the desired height and width for your curtains. Measure the window frame or the area where you want to install the curtain rod.
2. Using a pencil, mark the desired height on both sides of the window frame. Make sure the marks are level and evenly spaced.
3. Take the longer rod (the primary rod) and remove the finials from both ends. Slide the curtain rings onto the rod, ensuring they are evenly spaced.
4. Position the primary rod on the marked height, aligning it with the window frame. Use a level to ensure it is straight.
5. Once the primary rod is in place, mark the spots where the brackets will be installed. The brackets should be positioned approximately 4-6 inches from the ends of the rod and evenly spaced in between.
6. Using a drill and the provided screws, attach the brackets to the wall at the marked spots. Make sure the brackets are securely fastened.
7. Slide the primary rod with the curtain rings into the brackets. Ensure it is properly seated and level.
8. Take the shorter rod (the secondary rod) and remove the finials from both ends. Slide the secondary rod into the curtain rings on the primary rod.
9. Adjust the length of the secondary rod to fit the desired width of your curtains. The rod is extendable from 84 to 160 inches, allowing it to accommodate a range of window sizes.
10. Once the secondary rod is adjusted, secure it in place by tightening the set screws located on the brackets.
11. Finally, reattach the finials to both ends of the primary and secondary rods.
Please note that these instructions are a general guide. It is always recommended to refer to the specific user manual provided with the EXCLUSIVE HOME RD014861DSEH Double Curtain Rod Kit for detailed and accurate installation instructions.
Add New Comment