User Manual Q&AAnswer
Mar 13, 2025 - 10:32 PM
To install the MRCOOL MB176 Mini-Split Condenser Mounting Bracket, follow these steps:
1. Assemble the support bracket mounts by taking one component C and one component D. Stand component C upright and insert component D into the bottom of component C, aligning the bolt holes. Insert two bolts (Component M8x55 M-B) through the holes and secure them with nuts (Component M8 M-D). Insert component E into the hole at the base of the rear of component C. Take two bolts (component M8x25 M-A) and place washers (component B) onto them. Insert the bolts with washers into the front and rear slide holes on the top of component D. Put washers (component M-C) on the ends of each bolt and secure with nuts (component M-D).
2. Select a strong and permanent installation location for the bracket and condenser. Use Wall Plate A to determine the correct mounting location. Use a level to align the wall plate and mark the three holes on the surface to be mounted. If installing onto a studded wall, ensure the holes align with the studs. Drill holes into the mounting surface with a depth of approximately 2-3/4 in (70 mm).
3. Place the wall plate against the wall and align the mounting holes. Insert bolts (component W-A) through the wall plate and into the mounting holes. Tighten the bolts to secure the wall plate to the mounting surface.
4. Slide the support bracket mounts onto each side of the mounted wall plate in the correct position to accommodate the bottom of the condenser.
5. Mark the bottom hole on each support mount and remove the support bracket mounts from the wall plate.
6. Drill the marked holes on the mounting surface using the same drill bit and depth used for mounting the wall plate.
7. Slide the support bracket mounts back onto the wall plate and align the mounting holes. Insert the bolts from component W-A into the mounting holes and tighten them.
8. Mount the condenser to the bracket by slowly positioning it on the installed mounting bracket and ensuring it is firmly supported.
Remember to regularly check that the bracket is securely fastened and safe to use. If you have any questions or need further assistance, please contact your dealer or MRCOOL Support at 270-366-0457.
Add New Comment