User Manual Q&AAnswer
Mar 13, 2025 - 09:59 PM
To install the Alecto ADI-250 Door Intercom with Camera, follow these steps:
1. Charger:
- Insert the small plug of the adaptor cable into the bottom of the adaptor and plug the adaptor into a 230V wall socket.
- You may choose to place the charger on a table or use the 2 screws for wall-mounting.
2. Indoor unit:
- Slide the battery cover at the rear of the indoor unit down and off the indoor unit.
- Install the supplied battery pack in the indoor unit, connecting the plug to the battery input.
- Slide the battery cover back onto the indoor unit.
- You may also place the belt clip.
- Place the indoor unit into the charger and leave it there for 10-15 hours to properly charge the battery pack.
- The charge indicator will remain lit while charging.
3. Outdoor unit:
- You may choose to have the outdoor unit run on batteries or power it via a power adaptor. If using batteries, the monitor function will be unavailable.
- If using batteries, remove the protective cover by flipping off the cover using a screwdriver underneath the clip.
- Remove the battery cover by unscrewing the 4 small screws.
- Install the batteries, paying attention to the + and - signs. Preferably, use Alkaline batteries.
- Replace the battery cover onto the outdoor unit, fasten it with the 4 small screws, and replace the protective cover.
- If using a power adaptor, remove the seal cover by unscrewing the 4 small screws.
- Connect the 8-12V adaptor according to the illustration in the manual.
- Fasten the seal cover back onto the outdoor unit.
4. Mounting:
- Determine the installation height for the outdoor unit.
- Hold the suspension bracket against the wall at the desired height and draw the drill holes.
- Drill the holes, insert the plugs, and mount the suspension bracket. Use the built-in spirit level to ensure it is straight.
- If using an external power source, lead the wires through the hole in the rear of the suspension bracket and connect them to the connection strip.
- Slide the top of the outdoor unit into the suspension bracket and then push the bottom into the bracket.
- Fasten the outdoor unit into the bracket using the supplied xxxx .
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment