User Manual Q&AAnswer
Mar 13, 2025 - 09:57 PM
To install the Artwork Bodyshop VW ATLAS 20-23 Front Splitter, please follow these steps:
1. Remove each exterior xxxx under your bumper towards the wheels.
2. Align the splitter and install it with the provided Phillips screws in the factory holes to hold the splitter in place. You can use a car jack to hold the middle of the splitter up.
3. Use a 3/8" drill bit and drill holes under your bumper through the remaining holes of the splitter. Make sure the drill bit stays as straight as possible.
4. Remove the screws under your bumper to access inside the bumper. Assemble the splitter with spacers, bolts, and nuts as shown in the drawing. xxxx the nuts inside by hand until they are tight, and then use the hex key at the bottom of the splitter to tighten the bolts.
5. Reinstall all the removed screws and ensure everything is tight.
6. Take pictures of the installed splitter and send them to info@artworkbodyshop.com. Additionally, tag Artwork Bodyshop on social media @artworkbodyshop.
Please note that professional installation is strongly recommended for this product. Make sure to refer to the provided parts list and use the appropriate bolts, nuts, spacers, and screws during the installation process.
If you have any further questions or concerns, feel free to contact Artwork Bodyshop for assistance.
Add New Comment