User Manual Q&AAnswer
Mar 13, 2025 - 09:10 PM
To install the Hamron 023676 Light Bar LED, please follow these steps:
1. Before installation, make sure to read the instructions carefully and comply with applicable laws and regulations for the installation and use of auxiliary lights.
2. Disconnect the negative/chassis earth cable from the battery before connecting the product to avoid damage from short-circuiting during installation.
3. Follow the existing cable routing as much as possible for the installation of new cables. Securely fasten the cable and any excess length with cable ties, insulating tape, or equivalent materials.
4. If you need to drill a xxxx hole for installation, use a drill with a diameter of 8.5 mm in the surface where the product is to be installed.
5. Insert the xxxx into the hole, place the lock washer on it, and tighten the nut.
6. The product can be mounted using either the side fastener or the bottom fastener, depending on your preference.
Please refer to the provided manual for more detailed instructions and illustrations (refer to FIG. 1 and FIG. 2).
Note: It is always recommended to consult a professional or seek assistance if you are unsure about the installation process.
Add New Comment