User Manual Q&AAnswer
Mar 13, 2025 - 08:58 AM
To properly clean and maintain the ROBERTS 10-981-25 3 Inch Adhesive Applicator Nozzle, follow these steps:
1. After each use, it is important to prevent the adhesive from drying inside the nozzle. To do this, create an airtight seal by covering the ends of the nozzle with tape or by using a damp cloth.
2. To thoroughly clean the nozzle, flush it with water immediately after each use. Hold the nozzle under a faucet or use a spray bottle to direct water into the nozzle. Continue flushing until the channels run clear.
3. If there is any stuck-on adhesive or debris, you can use mineral spirits and a clean cloth to remove it. Apply a small amount of mineral spirits to the cloth and gently scrub the inside and outside of the nozzle.
4. Once the nozzle is clean, allow it to air dry completely before storing it. Make sure there is no moisture remaining inside the nozzle to prevent any potential damage or clogging.
By following these cleaning and maintenance instructions, you can ensure that the ROBERTS 10-981-25 3 Inch Adhesive Applicator Nozzle remains in good condition and ready for future use.
Add New Comment