Answer

Mar 13, 2025 - 03:36 AM
To install the GAGGENAU AR401142 Remote Fan Unit, follow these steps:
1. Check the wall: Ensure that the wall is vertical and has sufficient load-bearing capacity. Make sure there are no electrical wires, gas pipes, or water pipes in the area where holes are to be drilled.
2. Prepare the wall: Fit the exhaust air pipe with a 1° gradient from the appliance to prevent condensation from returning. Create a wall breakthrough with a diameter of at least 210 mm and insert the AD702042 telescopic wall outlet into the wall breakthrough. Secure and seal the telescopic wall outlet with foam or mounting adhesive. Drill mounting holes and a cable passage into the outside wall.
3. Install the appliance: Press in the wall plugs flush with the wall. Seal the fixing plate against the outside wall and tighten it. Guide the mains cable and control cable through the outside wall. xxxx the remote fan unit onto the fixing plate and secure the exhaust air pipe to the inside of the wall outlet. xxxx the inner control unit tightly into the wall.
4. Connect the appliance: Fit the plug into the mains cable, ensuring the correct connection of the wires. Fit the connector parts and tighten the screws for strain relief. Firmly insert the mains cable and control cable from the remote fan unit into the control unit. Firmly insert the network cable from the control unit to the extractor hood. Connect the control unit to the mains.
5. Check the function: Verify the functionality of the appliance. If it does not work, check the plug connections for the connection cables.
Please note that these instructions are a summary and it is essential to refer to the complete instruction manual for detailed installation steps and safety precautions.
Add New Comment