User Manual Q&AAnswer
Mar 13, 2025 - 03:20 AM
To calibrate the pH probe on the Station 30-202000 Chemical Control and Pool Control, follow these steps:
1. Make sure the pool system is running and the pH probe is connected to the device.
2. Go to the "Measures" menu on the device.
3. Select "Calibration" and choose the pH probe calibration option.
4. The device will prompt you to calibrate with buffer solutions pH7, pH10, and neutral.
5. Follow the instructions on the display to perform the calibration. This usually involves dipping the probe in each buffer solution and allowing the device to read and adjust the values.
6. After the calibration is complete, the device will display the calibrated pH value.
7. If needed, you can also perform a manual calibration by adjusting the reading of the probe using the + / - buttons on the device. This is recommended only for small deviations in the readings.
It is recommended to calibrate the pH probe every month during the pool season to ensure accurate measurements.
Add New Comment