User Manual Q&AAnswer
Mar 13, 2025 - 12:31 AM
The BAPI 49583 EZ Pressure Sensor can be mounted using three different methods: DIN rail mounting, snap track mounting, or surface mounting. Here are the steps for each method:
DIN Rail Mounting:
1. Pull out the blue mounting tabs on the EZ Mount Base.
2. Catch the EZ mount hook on the DIN rail.
3. Rotate the EZ pressure module down until the bottom mounting tab snaps into place on the DIN rail.
4. Connect wires and pressure lines as needed.
Snap Track Mounting:
1. Push in the blue mounting tabs on the EZ Mount Base.
2. Snap the EZ Mount base into the board slots in the 2.75 inch snap track.
3. Connect wires and pressure lines as needed.
Surface Mounting:
1. Pull out the blue mounting tabs on the EZ Mount Base.
2. Place the EZ Pressure unit against the surface and mark the xxxx holes.
3. Drill 1/8” pilot holes for #8 flathead screws.
4. xxxx the unit to the surface. The holes in the blue mounting tabs are elongated to allow for alignment.
5. Connect wires and pressure lines as needed.
Please refer to the BAPI 49583 EZ Pressure Sensor Instruction Manual for more detailed instructions and illustrations on mounting the sensor.7
Add New Comment