Answer

Mar 11, 2025 - 04:47 AM
To install the welldana D37-203310 Liner Inlet 2"x50mm 20mm Eyeball, follow the instructions provided in the user guide. Here is a step-by-step guide:
1. For a masonry structure without a liner:
- Seal the wall fitting (ref 3350) into the concrete of the basin wall, with the part with the inner threading towards the basin.
- xxxx the body of the inlet/outlet or vacuum fitting (7) into the wall fitting component.
- For a directional outlet: using the spanner (ref 3390), fit the nut of the rotary joint (6) in the body (7) at the desired height. Then mount the rotary joint (5) and fit the cover on the entire assembly (1).
2. For a polyester structure - shell:
- Follow the same steps as for a masonry structure without a liner, but use the rear nut ref 3394 instead of the wall fitting.
3. For a masonry structure with a liner:
- Follow the steps for a masonry structure without a liner, but use the wall fitting ref 3352 (sealed into the concrete).
- Add the flange (3), gaskets (4), and the four big screws (2) to ensure a waterproof seal with the liner.
4. For a panel structure:
- Follow the steps for a polyester structure - shell, but use the rear nut ref 3393 instead of the wall fitting.
- Add the flange (3), gaskets (4), and the four big screws (2) to ensure a waterproof seal with the liner.
- Important: Instead of fitting the rear nut, you can also install the body (7) outside the swimming pool and secure it in position using two small thread-cutting screws (2).
5. Winterizing:
- For the inlet/outlet fittings, use the winterizing plug 3392 or 3395, or plug 3391.
- For the inlet fittings, use the winterizing plug 3391.
Please note that the manufacturer cannot be held responsible for any direct or indirect damage resulting from the incorrect use or installation of the product.
For more detailed information and illustrations, refer to the user guide provided with the welldana D37-203310 Liner Inlet 2"x50mm 20mm Eyeball.
Add New Comment