Answer

Mar 11, 2025 - 04:41 AM
To install and set up the KRIPSOL San Sebastian Filter, follow these steps:
1. Place the valve (selection valve) making sure that the O-rings are correctly placed, and xxxx the nuts manually until a hermetic closing is reached.
2. Remove the lid and fill the filter up to 1/3 level with water. To prevent sand from entering through the diffuser, either turn it or cover it.
3. Fill the filter with the specified quantity of sand and place the diffuser into its initial position, uncovered.
4. Close the filter with the lid, ensuring that the O-ring gasket is placed correctly.
5. To hermetically seal the lid, tighten the bolts with their washers evenly.
6. Connect the pipes.
7. Turn the valve into the BACKWASH position.
8. Start the pump for at least one minute.
Important cautions:
- Never shift the valve handle position while the pump is running.
- Never disassemble the valve while the filter is under pressure.
For more detailed instructions and information about the KRIPSOL San Sebastian Filter, please refer to the instruction manual provided.
Add New Comment