User Manual Q&AAnswer
Mar 11, 2025 - 04:10 AM
To charge the batteries of the MONACOR 1000769 Audio Transmission System, follow these steps:
1. Before charging, switch off both the transmitter and the receiver by pressing and holding the on/off button (5) for approximately 3 seconds until the LEDs go out.
2. Connect the micro USB plugs of the charging cable (fig. 5) to the micro USB ports (6) on the lower sides of the transmitter and the receiver.
3. Connect the USB plug of the adapter to the USB port of a computer or a 5V power supply unit with a USB port.
4. The LED "LO/CHG" (3) on both the transmitter and the receiver will light up red, indicating that the batteries are being charged.
5. When the batteries have been fully charged, the LED "FULL" (4) on both the transmitter and the receiver will light up green.
6. To check the charging status, briefly press the on/off button (5) when the device is switched off. The LED "LO/CHG" (3) will flash red up to 4 times, depending on the charging status. Four flashes indicate that the battery is fully charged, while no flashing indicates that the battery is discharged and needs to be charged.
Note: The devices cannot be used while their batteries are being charged. It is recommended to fully charge the batteries before first use.
Please refer to the instruction manual for more detailed information and illustrations on charging the batteries (pages 2-3).
Add New Comment