How do I assemble and install the SOL-EXPERT Water Pump Set for crafting and experimenting? (SOL-EXPERT Water Pump Set Crafting Experimenting User Manual)

Answer

manuals.plus

Mar 11, 2025 - 03:54 AM

To assemble and install the SOL-EXPERT 50036 Water Pump Set, please follow the instructions provided in the user manual. Here is a step-by-step guide:

1. Start by pressing in the seal, ensuring it lies flat.

2. Push the motor into the housing, but only halfway.

3. Apply a thin bead of adhesive all around the motor to seal it. Use a gap-filling adhesive like Uhu Max Repair Power.

4. For additional security, you can apply a small amount of glue between the motor and the edge of the housing.

5. Place the mounting ring flat on a table.

6. Put the water wheel in the assembly ring.

7. Push the motor all the way in and press it firmly into place with a clamp while the glue dries. Allow the glue to dry completely.

8. Once the glue has hardened, the motor will be permanently attached to the gasket, preventing water from entering the motor from below.

9. Make sure the glue is fully cured before proceeding with further assembly.

10. Press the housing against the mounting ring from above, ensuring pressure on the motor. This will set the optimum height for the water wheel. If the motor comes loose, glue it in place again.

11. Press the lower part of the housing (gluing is not necessary) and attach the hose.

12. If needed, mount or glue the pump holder.

13. It is important to only use distilled water to prevent calcification of the pump.

14. Pay attention to the red marked line and fill the water only up to that point. Do not let the motor come into contact with water, as it will cause damage.

If you have any further questions or need additional assistance, please refer to the SOL-EXPERT 50036 Water Pump Set user manual or contact SOL-EXPERT directly using the provided contact information in the manual.