Answer

Mar 10, 2025 - 04:21 AM
To connect your speakers to the OSD AUDIO NEROXA5 Home Theater Amplifier, follow these steps:
1. Strip 10 to 15 mm of the wire insulation of the speaker cable.
2. Unscrew the output terminal binding post on the rear panel of the amplifier.
3. Insert each wire into the correct terminal, ensuring that the + terminal goes to the + terminal of the speakers and the - terminal goes to the - terminal of the speakers. You can determine the polarity by checking the marking on the speaker wire. Usually, the red wire is +.
4. Tighten the binding post by twisting it clockwise until it firmly clamps the speaker wire.
5. If you are using spades or banana plugs, simply insert them into the correct terminals.
It is important to note that misconfiguration of loudspeaker mode and incorrect connection of loudspeakers could damage the connected loudspeakers and/or the amplifier. If you are unsure about the installation process, it is recommended to seek assistance from a qualified installation professional.
Add New Comment