User Manual Q&AAnswer
Mar 10, 2025 - 04:07 AM
To set the desired temperature on the terneo ROL Smart Control of Heating thermostat, follow these steps:
1. Turn on the thermostat by twisting the control xxxx clockwise until it clicks.
2. The indicator light will start flashing green, indicating the installed power of the load.
3. Continue turning the control xxxx clockwise until it stops. The indicator will blink again.
4. Now, turn the control xxxx counterclockwise until it stops, but do not turn off the thermostat. Wait for the indicator to flash green.
5. Finally, turn the control xxxx clockwise until it stops. The indicator will blink to show the installed power.
6. Set the desired temperature by adjusting the control xxxx . For example, setting the xxxx to 25 °C corresponds to approximately 2.5 kW. The indicator will display the corresponding pulses to indicate the set power.
7. Exit the power setting mode by either turning off the thermostat or leaving the control xxxx in the set position until the indicator displays the set power three times in a row.
Please note that the thermostat has a temperature range of 0 to 35 °C and a temperature hysteresis of 1 °C.
Add New Comment