How do I install the PROSLAT Heavy Duty Hoist? (PROSLAT Heavy Duty Hoist Installation Guide)

Answer

manuals.plus

Mar 09, 2025 - 06:25 PM

To install the PROSLAT Heavy Duty Hoist, please follow these steps:

Step 1: Ensure that your hoist is attached to a solid wood ceiling joist that is 2" x 4" or larger.

Step 2: Mount the back pulley and the front pulley to the ceiling using two wood screws each. The distance between the two pulleys should match the measurement made in step 1. Pre-drilling 1/8" pilot holes in the ceiling will make mounting the pulleys easier.

Step 3: Attach the pulley brackets to the ceiling mounts.

Step 4: Untangle the rope and tie each end of the rope to a ceiling bracket on the hoist. Thread the left side rope through the brake device, then through the first pulley, second pulley, down around the second hook, and up to the ceiling bracket. Tie a figure-eight knot right after the hole in the ceiling mount, followed by a double knot around the bolt. Repeat the same process for the right side rope.

Step 5: Mount the rope cleat to the wall using two wood screws. When the bike is lifted to the ceiling, store the excess rope in the cleat.

For detailed illustrations and further instructions, please refer to the PROSLAT Heavy Duty Hoist Installation Guide provided with the product.

Please note that it is important to test the fully-weighted product (with equipment in place) before use to ensure proper installation. Also, ensure that there are no obstructions that could restrict the operation of the hoist.

For additional information and warranty details, please refer to the PROSLAT Hoist Warranty and Disclaimer of Liability sections provided in the manual.