User Manual Q&AAnswer
Mar 08, 2025 - 09:41 AM
To connect the HV9658 IP66 Constant Voltage LED Driver to your LED lights, please follow these steps:
1. Ensure that the power is turned off before starting the installation process.
2. Connect the output cable of the LED Driver to the light source, making sure that the polarity is correct. If the Driver has two output cables, they can be joined to form one connection point.
3. If the connections will be exposed to outdoor conditions, it is important to cover the connections using an adhesive-lined heat shrink or gel cap to make them watertight. Failure to do so will void the warranty.
4. Once the connections are secure, plug the 240v plug of the LED Driver into a power outlet.
5. Turn on the power after the LED Driver is plugged in.
Note: If you hear a ticking noise when the LED Driver is turned on, it indicates a short on the run. In this case, turn off the Driver, inspect all connections, and ensure they are properly secured before turning it back on.
Please remember that the installation of the HV9658 IP66 Constant Voltage LED Driver should be done by a licensed electrician, following the safety regulations outlined in the AS/NZS 3000 standard.
Add New Comment