How do I install the niko finishing set for a switch or push button? (Niko finishing Set Switch User Manual)

Answer

manuals.plus

Mar 08, 2025 - 08:49 AM


To install the niko 124-61105 finishing set for a switch or push button, please follow the steps below:

1. Start by ensuring that the power to the switch or push button is turned off at the circuit breaker.
2. Remove the existing faceplate and switch or push button from the wall.
3. If necessary, adjust the flush-mounting box so that it is level with the wall surface.
4. Take the central plate of the finishing set and align it with the flush-mounting box. Ensure that the rectangular openings on the central plate match the snap hooks on the flush-mounting box.
5. Press the central plate firmly against the flush-mounting box, allowing the snap hooks to secure it in place. The multi-positional snap hooks can compensate for any margin between the flush-mounting box and the wall surface.
6. Once the central plate is securely attached, position the faceplate over it. The round openings on the flat edge of the central plate will help ensure the correct positioning of the faceplate.
7. Attach the faceplate to the central plate by aligning the  xxxx  holes and using the provided screws.
8. Finally, turn the power back on at the circuit breaker and test the switch or push button to ensure proper functionality.

Please note that this is a general guide and it is always recommended to refer to the specific instructions provided in the user manual for your niko 124-61105 finishing set for precise installation steps.