User Manual Q&AAnswer
Mar 08, 2025 - 07:59 AM
To install the , follow these steps:
1. Assemble and tighten the product and the accessories through the ball head nut. You can also use other accessories with a ball head diameter of 17mm.
2. Fix the car charger holder in the desired position.
3. Connect the product to a QC3.0 car charger (optional) using the provided Type-C cable.
4. Plug the car charger into the cigarette lighter to power the device.
To use the Shenzhen Caibo Technology MG6 Magnetic Wireless Car Charger Holder, follow these steps:
1. After the product is powered on, the indicator light will turn on, indicating that it is ready for use.
2. Place your phone on the holder. The magnetic suction force will automatically attach the phone to the holder, aligning the charging coil.
3. The product will start wireless charging, and the indicator light will display a breathing effect.
4. If your phone does not support wireless charging or if a metal foreign object is detected, the indicator light will flash alternately for 5 seconds and then turn off.
5. The maximum charging power of this product is 15W, and the charging efficiency may vary depending on the charging environment and your mobile phone.
6. For optimal wireless charging, ensure that the distance between the phone and the charger is within 3-5mm and avoid using metal or thick (over 3mm) phone cases.
When you remove the phone from the holder, the indicator light will immediately show the standby status. If the car engine is turned off and the power supply stops, the indicator light will turn off. The phone will still be attached to the holder by magnetic force and can be easily taken off at any time.
Please note that the Shenzhen Caibo Technology MG6 Magnetic Wireless Car Charger Holder requires a QC3.0 / 18W+ PD car charger for optimal performance.
Add New Comment