User Manual Q&AAnswer
Mar 08, 2025 - 06:29 AM
Installation of the TAC 3S-F112T 3 Inch Side Bar on your Ford F150 or F250 Super Duty requires the following steps:
1. Start the installation on the driver side of the vehicle. Locate the front, center, and rear factory running board mounting locations along the inner side of the body.
2. Slide one plastic washer over each factory mounting stud in the body panel. These plastic washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the brackets without the plastic washers.
3. Attach the driver side front mounting bracket (same bracket used for passenger side rear installation) to the three factory studs using three 8mm flat washers and three 8mm nylon lock nuts. Snug but do not fully tighten the hardware.
4. Install the driver side center bracket using the same process as step 3.
5. Install the driver side rear bracket using the same process as step 3.
6. Position the driver/left sidebar with the assistance of another person. Attach the sidebar to the mounting brackets using the included two 1/2" x 2" hex bolts, two 1/2" lock washers, and two 1/2" flat washers. Leave the hardware loose at this time.
7. Line up the threaded insert in the bottom of the sidebar with the center bracket. Attach the sidebar to the bracket using one 8mm x 25mm hex bolt, one 8mm lock washer, and one 8mm flat washer. Leave the hardware loose at this time.
8. Level and adjust the sidebar, then tighten all hardware.
9. Repeat steps 1-8 to install the passenger/right sidebar.
10. Periodically inspect the installation to ensure that all hardware is secure and tight.
To protect your investment, wax the product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel finishes, aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap can also be used to clean the sidebar.
For gloss black finishes, mild soap can be used to clean the sidebar.
Please refer to the provided instruction manual for visual references and additional details.
Add New Comment